Our sensor comes outfitted with a standard Racepak connector already attached plus the mating connector and fine thread nuts are included to make your installation a snap.
Sensor gap should be 0.020-0.040" Measure with feeler gauge or screw in until sensor touches reluctor ring then back out 1/2 to 1 full turn.
The sensor has an LED in the end so you can test if it's reading your target just by watching the light flash. These are perfect for any normal ferrous toothed wheel, ABS ring or even the bolt heads under a rotor hat. Will also fit the Strange Ultra housing.
HOLLEY USERS-
It can receive 12v power from any source you like. For the signal J1A12 or A3 are preferred.
Suggest using a22 ground, b20 power, shield drain j2-b14
10-30 volt power
5/16" X 24 thread pitch (fine)
Cable is 16" long
Our PRO-SERIES Driveshaft Reluctor Ring is here-
https://madracingparts.com/products/mad-pro-series-driveshaft-reluctor-ring
Customer Reviews
Glenn and the crew at MAD are some of the most knowledgeable in the game when it comes to getting the right products for what you're trying to accomplish. Highly recommend them.
MAD PRO-SERIES DRIVESHAFT SENSOR FOR FERROUS TOOTH TARGET
I love y’all quality parts. Keep up the good work. Thank you for the treat that was in the box right on.
👍
Easy install, product well thought out!
